Repair my Clip Mini Bluetooth Handsfree

My clip mini bluetooth handfree has been malfunction for quitesometime. After further verification, i found out that the connection wire inside were broken. So, i have cut both end completely. After stripping the wire, i was almost fainted. The wire is special type. What is special? oh... the wire has a coating on it, so, this means, it is not easy to reconnect back, for eg, twist both wire -does not work here.

The only solution is, i have to make sure wire tip need to have connection to the other tip. To be honest, to solder in such way, its not possible. So, my use lighter to burn the coating of wire, hoping the coating are burnt off. Then i pair them together, make sure all tips are close to each other, then i use soldering method, make sure the tips are well soldered.

I need soldering gun and solder tin of cos.

Then, i use heat shrink tubing to cover back the connection. Well, it look nicer, isn't it?

Moment of truth again? Yes, it works fine now, the on/off button able to work, i can answer the phone, i can listen to wat the other end say. But one weak point is, the noice level are quite high, this might be due to poor connection as it is not original anymore. But I dun give a shit, as long as i can use back my handfree.

Wireless can be real cool... heck, no need to spend mponey to buy a new one...money saved for other use....hahahahah... yay!